Casey Walker using J&S 5 Main Girdle / Stage V
Edelbrock heads.Custom J&S Hyd. Roller Camshaft.
Jim @ J&S Assembled the Short block into a Long block .Which included the machining of main
caps for the J&S 5 main BB Girdle,Installation and degreeing of Roller Cam , installing the J&S
Stage V Heads , then topping it off with the New Edelbrock RPM # 7551 intake. The engine was
then pre-run @ J&S prior to going to Dyno.
600 HP / 600 FT LB TQ. On 93 pump gas !!
Casey is currently running 10:50 s 1/4 mile
This is with a "Stock" cast crank
J&S 5 Main Girdle !!
       Dyno Sheet on Left
Video on J&S Running Stand
       At initial Start-Up !!
Great Job of getting it Dialed in
             Casey !!!